NITROUS OXIDE ( nos / n2o ) advice forum
http://nitrous-advice.org/

Is there a formula...
http://nitrous-advice.org/viewtopic.php?f=6&t=7527
Page 1 of 1

Author:  Goyle [ Thu May 25, 2017 2:47 pm ]
Post subject:  Is there a formula...

I was chatting to someone today who is interested in Nitrous, and I was explaining that Nitrous adds more torque than horse power.

Then they asked the question... How much extra torque does nitrous add ?

and I have to be honest i didnt know :?

So my question is... is there some kind of formula which roughly works out how much extra torque compared to horse power nitrous adds ?

Thanks in advance 8)

Author:  Turbobox [ Thu May 25, 2017 6:31 pm ]
Post subject:  Re: Is there a formula...

BHP * 5252 / rpm = Trq (ft. lbs)

Trq (ft. lbs) / 5252 * rpm = BHP


50 * 5252 / 3000 = ~ 87.5 Ft Lbs

87.5 / 5252 * 3000 = ~ 50 BHP

:yes: :yes:

Author:  Goyle [ Thu May 25, 2017 7:21 pm ]
Post subject:  Re: Is there a formula...

Cheers :cheers:

Author:  Noswizard [ Wed Jun 14, 2017 9:22 pm ]
Post subject:  Re: Is there a formula...

Based on many results that I've achieved and had reported to me, an 'average' engine will make at least as much torque as it does power, so a 25 HP jet will make at least 25 ftlbs of torque. However, just as some engines make more power from a given amount of nitrous, some engines will make more torque and sometimes, that also applies relative to the power increase.

The fact of the matter is this; there are very few constants that apply equally across a wide range of engines, each has to be measured in its own right, which is where the formulas given by Alex come in handy.

Author:  Goyle [ Wed Jun 14, 2017 9:41 pm ]
Post subject:  Re: Is there a formula...

Noswizard wrote:
Based on many results that I've achieved and had reported to me, an 'average' engine will make at least as much torque as it does power, so a 25 HP jet will make at least 25 ftlbs of torque. However, just as some engines make more power from a given amount of nitrous, some engines will make more torque and sometimes, that also applies relative to the power increase.

The fact of the matter is this; there are very few constants that apply equally across a wide range of engines, each has to be measured in its own right, which is where the formulas given by Alex come in handy.


Great to see you on the forum again, and thank you for the informative reply :yes:

Page 1 of 1 All times are UTC
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/