NITROUS OXIDE ( nos / n2o ) advice forum

View unanswered posts | View active topics

Board index » Related to: Nitrous Oxide / N20 / NOS » General Nitrous Oxide (NOS / N2O) Discussion

All times are UTC

Tapping into the factory fuel line for the fuel solenoid

Moderators: Brett928S2, T.F.S., Noswizard, chip

Page 1 of 1

[ 2 posts ]

Print view

Previous topic | Next topic

Author

Message

Pepi

Post subject: Tapping into the factory fuel line for the fuel solenoid

Posted: Wed Jan 14, 2015 1:33 am

Newbie

Joined: Tue Sep 02, 2014 4:49 am
Posts: 17

Starting to plumb in my system and I've measured the stock rubber fuel line i.d. to be 8mm.

The tee which I have to tap into my fuel supply for the fuel solenoid has barbs on it that have a 7mm o.d. and a 6mm i.d.

Will this downsizing the fuel line i.d. at the tee from 8mm to 6mm be a cause of concern, from a flow/supply point of view - whether on or off the juice?

Cheers!

Top

Noswizard

Post subject: Re: Tapping into the factory fuel line for the fuel solenoid

Posted: Fri Jan 16, 2015 7:28 pm

Site Admin

Joined: Thu Feb 03, 2005 6:07 pm
Posts: 18701
Location: Doncaster

We have larger size barbs that would be better fitted in place of the 7mm versions we offer as standard.

_________________
Regards

Trev (The WIZARD of NOS)

30 years of nitrous experience and counting!!!!

Top

Page 1 of 1

[ 2 posts ]

Board index » Related to: Nitrous Oxide / N20 / NOS » General Nitrous Oxide (NOS / N2O) Discussion

All times are UTC

Who is online

Users browsing this forum: No registered users and 25 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:

Tapping into the factory fuel line for the fuel solenoid

Advertisement

Who is online