NITROUS OXIDE ( nos / n2o ) advice forum

Wasnt sure about using a barbed T piece, and from what googling has revealed they arent suitable. However, I dont see any other way, the plastics run front to rear, in tank pump so no banjo option, and no Schrader pressure release valve.
Car is 2002 Clio 172.

Any ideas?

Why not measure the od of the pipe and get some compression fittings with 1/8bsp threads and use the t peice

They are normally 8mm OD pipe and we offer a compression type T with appropriate nuts and olives, just call the office and make your order as described above.

Is that the 3way 8mm tee as shown on the main site? If so, would I need a further adapter to go from the 8mm to the 5mm nylon fuel line?

You'll need the following parts;

1 x http://www.noswizard.com/nitrous-ancill ... f-f-f.html

1 x http://www.noswizard.com/nitrous-ancill ... ducer.html

1 x http://www.noswizard.com/nitrous-ancill ... lives.html