NITROUS OXIDE ( nos / n2o ) advice forum

As above really how many pulsoids will a max extreme run I assume more fuel than nitrous

Thanks

Hi

Well mine (Maxx Extreme Race/Revo V2) is running 9 plus 4 revos

My previous Maxx Extreme V1 was running 8 plus 4 revos...

All the best Brett

Oh so loads then lol I didn't realise all yours were running straight of the max controller

you enjoying the new stuff then lol

I'm assuming Brett uses a mosfet box to earth the high amperage draw of all the pulsoids, and the controller signals the mosfet box?

Paul

Hi Paul

Thats how it worked with the Maxx1 ..or rather there was a Revo Driver box, but the Maxx 2 powers and drives everything...its truly amazing

All the best Brett

Hi

Just a little lol

All the best Brett

Not sure wat the gets can do but a nitrous pulsoid is about 10 amps and a fuel is about 4 amps obviously that's fully open and less with pwm just not sure what the maximum current Each fet can do

Even the original Max is 'rated' to an insanely high amount of Amps (can't remember the exact figure now but should be on the spec page) but unfortunately the actual current rating is much less than the FET 'ratings'. Thankfully it's still higher than ANY other progressive unit and enough for most people's requirements and as Brett has stated, the Max V2 has even more current carrying capacity.

Having said that, in Brett's case they are NOT all powered off the same pulsed output, as we use different outputs for different jobs.
Some people may require a large number pulsed all at the same time and in that case the limits are lower than in Brett's case and as different solenoids/Pulsoids pull different current, it's best to check for a specific application.

It's for a friend so I don't know the exact requirements he just asked me so I said I didn't know

Thanks for the replys everyone