|
Learner |
|
Joined: Mon Nov 30, 2009 7:53 pm Posts: 437 Location: Holland
|
Those are impressive engine specs Ron. I see you have an initial bore of 4.5 inch. I heard the a460 block has enough "meat" to be taken out to 4.625 inch with block filler, is that correct? That would mean the engine can be overbored and honed many times during its lifecycle.
_________________ Paul 2008 FN2 CTR N.A. 13.9 sec. E.T. 164 km/hr
Diy short ram intake, TBS, throttle coolant block off, heat shield gasket, AAS race manifold, reinforced torque rods, Exedy stage 1 clutch, short shifter,semi slicks, hondata flashpro.
|
|