NITROUS OXIDE ( nos / n2o ) advice forum
http://nitrous-advice.org/

Real porn for you all
http://nitrous-advice.org/viewtopic.php?f=5&t=5691		 Page 1 of 1
Author:  insaneron [ Tue Jan 18, 2011 7:22 pm ]
Post subject:  Real porn for you all
Image
Image
Image
Image
Image
Image

ImageImage

Image
Image

Image
Image
Image
Author:  Figure11 [ Tue Jan 18, 2011 9:15 pm ]
Post subject:  Re: Real porn for you all
Phwooorrrrr......where's me special sock?
Author:  BMW840 [ Tue Jan 18, 2011 9:38 pm ]
Post subject:  Re: Real porn for you all
Figure11 wrote:
Phwooorrrrr......where's me special sock?

:omgrofl: you must be ex army with that comment
Author:  Noswizard [ Wed Jan 19, 2011 1:20 am ]
Post subject:  Re: Real porn for you all
Those pistons look AWESOME and should handle the 1,000 extra HP you're intending to throw at them. :twisted:

The rods also look the business, so that combination should hold together nicely. :yes: :yes:
Author:  insaneron [ Wed Jan 19, 2011 7:32 am ]
Post subject:  Re: Real porn for you all
Fingers crossed Its booked into the dyno for next friday I now have the sump and inlet gaskets along with my new fuel pumps so I can make a start on that as well
Author:  Figure11 [ Wed Jan 19, 2011 4:12 pm ]
Post subject:  Re: Real porn for you all
BMW840 wrote:
Figure11 wrote:
Phwooorrrrr......where's me special sock?

:omgrofl: you must be ex army with that comment


The Navy. And remeber, ones mans' special sock is the one his mate puts on in the morning!!!!!!
Author:  mgbv8 [ Wed Jan 19, 2011 7:53 pm ]
Post subject:  Re: Real porn for you all
Very nice Ron!!
All nice and shiny too...

Now stop pissing around and get that thing built and dyno'd so you can come and play with us at the Pod for shakedowns :D :D

Just dont use a Figure 11 air filter mate. It may possibly be quite choked up :rofl: :beatstick: :rofl:

See you soon dude!!!

Regards
Pel
Author:  insaneron [ Wed Jan 19, 2011 11:27 pm ]
Post subject:  Re: Real porn for you all
Whats an air filter
Author:  BMW840 [ Thu Jan 20, 2011 11:46 am ]
Post subject:  Re: Real porn for you all
insaneron wrote:
Whats an air filter

Thats a good point, I'll remove mine when next at the strip :yes:
Author:  mgbv8 [ Thu Jan 20, 2011 2:55 pm ]
Post subject:  Re: Real porn for you all
insaneron wrote:
Whats an air filter


That thing I put on my car so no crud gets in while its on the trailer. Then it gets used as a tea tray while I'm on track :rofl:
Author:  insaneron [ Thu Jan 20, 2011 6:24 pm ]
Post subject:  Re: Real porn for you all
Thats the benifit of a rear facing scoop
Author:  mgbv8 [ Thu Jan 20, 2011 7:48 pm ]
Post subject:  Re: Real porn for you all
insaneron wrote:
Thats the benifit of a rear facing scoop


I do like the idea of changing to that setup I must admit. Can you buy them as glass fibre mouldings to bolt on. Or do you get your own folded up out of ally ??

Pel
Author:  insaneron [ Thu Jan 20, 2011 10:35 pm ]
Post subject:  Re: Real porn for you all
I made the bonnet out of steel including the scoop then took a mould then laid up the bonnet
Author:  mgbv8 [ Fri Jan 21, 2011 8:31 pm ]
Post subject:  Re: Real porn for you all
Hmm!
So I need to find a local glass fibre guy eh?
Author:  insaneron [ Sat Jan 22, 2011 1:21 am ]
Post subject:  Re: Real porn for you all
I could ask my mate if he would do tou a scoop from my mould but not sure when that would be or if you know someone you can borrow mould and make your own
Author:  Noswizard [ Sat Jan 22, 2011 2:55 pm ]
Post subject:  Re: Real porn for you all
Ron you should add your website link as your signature.

In this instance it would help me to review the changes you've made as I've misplaced the link to it. :redface:
Author:  mgbv8 [ Sat Jan 22, 2011 3:17 pm ]
Post subject:  Re: Real porn for you all
insaneron wrote:
I could ask my mate if he would do tou a scoop from my mould but not sure when that would be or if you know someone you can borrow mould and make your own


I reckon I can get my sheet matal guy to maske me one from thin ally to match the bonnet.
That would be a start eh?
Author:  insaneron [ Mon Jan 24, 2011 12:02 am ]
Post subject:  Re: Real porn for you all
Ok Trev
Signiture now done

Good and bad news on the test fire up over the weekend. I managed to get the engine turning ove and oil pressure along with holding water.

The bad bit is we couldn't get it to fire. The problem is due to a combination of 12.75/1 comp ratio and not having a torque converter bolted to the flex plate, as the engine was turning the starter was pushing the flex plate back. When we the put fuel and spark to the mix it was enough to push the ring gear off the gear on the starter. We suffer a few slightly damage teeth so the best course of action was to wait until Friday.

So sorry no footage or it running. but I did get 80psi oil pressure on the starter.
Author:  Noswizard [ Mon Jan 24, 2011 1:12 am ]
Post subject:  Re: Real porn for you all
insaneron wrote:
Ok Trev
Signiture now done
Great improvement to the site, all you need now are the up to date pics. :yes:

Good and bad news on the test fire up over the weekend. I managed to get the engine turning ove and oil pressure along with holding water.

The bad bit is we couldn't get it to fire. The problem is due to a combination of 12.75/1 comp ratio and not having a torque converter bolted to the flex plate, as the engine was turning the starter was pushing the flex plate back. When we the put fuel and spark to the mix it was enough to push the ring gear off the gear on the starter. We suffer a few slightly damage teeth so the best course of action was to wait until Friday.

So sorry no footage or it running. but I did get 80psi oil pressure on the starter.
Sorry to hear that Ron but I was concerned about having such high compression (especially with the traget you have on nitrous), any chance of some thicker headgaskets?
Author:  insaneron [ Mon Jan 24, 2011 11:10 pm ]
Post subject:  Re: Real porn for you all
All in good time sir
Seriously I sent all the info over to my Web guy at the end of last week so should be in the next couple of days but just for you
STREET ELIMINATOR RACE DATES FOR 2011.


Round 1 Santa Pod raceway: - Easter Thunder Ball
April: - Fri 22nd / Sat 23rd / Sun 24th / Mon 25th
Round 2 Santa Pod raceway: -The Main Event
May: -Fri 27th / Sat 28th / Sun 29th /Mon 30th

Round 3 Santa Pod raceway: - Summer Nationals
June: -Sat 25th / Sun 26th

Round 4 Santa Pod raceway: - Bug Jam
July: -Fri 22nd / Sat 23rd / Sun 24th

Round 5 Shakespeare County raceway: - Open Sport Nationals
August: - Sat 27th / Sun 28th / Mon 29th

Round 6 Santa Pod raceway: - European Finals
September: -Thu 8th / Fir 9th / Sat 10th / Sun 11th


Round 7 Santa Pod raceway: - National Finals
September: - Sat 24th / Sun 25th
Author:  insaneron [ Mon Jan 24, 2011 11:20 pm ]
Post subject:  Re: Real porn for you all
We think we've sorted out the issue with the flexplate/starter issue.

Because the Block Bell housing and Starter are "RACE" spec so slightly thicker than standard we only had 3mm engagement in the teeth on the flexplate. As we can't machine the block now and the bell housing is SFI so can't do that either our only option is make a new bearing suppoert for the starter.

I love it when everything is 3 times the cost of standard parts it means that you know they wont fit.
Author:  mgbv8 [ Wed Jan 26, 2011 7:58 pm ]
Post subject:  Re: Real porn for you all
I love it when everything is 3 times the cost of standard parts it means that you know they wont fit.


Classic comment mate :rofl:
Author:  insaneron [ Thu Jan 27, 2011 12:11 am ]
Post subject:  Re: Real porn for you all
OK here's a little fact that I thought I'd share with you all.
I'm getting everything ready to load up tomorrow night. I spoke to Pete Dyno guy. he said we will need to bring around 50-60 litres of fuel, if were playing with adatives 75 litres, if were playing with nitrous settings 80-100 litres. Not bad figures for a "STREET" engine.
Page 1 of 1 All times are UTC
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/